![name at least five different scans that may be performed with zenmap name at least five different scans that may be performed with zenmap](https://sxi.io/wp-content/uploads/2020/02/img_5e449f994ea7d-512x400.png)
![name at least five different scans that may be performed with zenmap name at least five different scans that may be performed with zenmap](https://venturebeat.com/wp-content/uploads/2018/08/IMG_20180830_095804.jpg)
It detects the Operating system as well as the version of OS. It is faster than the normal scan because it scans the fewer ports and uses the aggressive timing template Quick scan plusĬommand = nmap -sV -T4 -O -F –version-light It does not scan the ports of that particular target/targets. Ping scan only finds either target/targets are up or not. The benefit is that you can check all the vulnerabilities in the network where you are connected with. Intense Scan is to comprehensive scan the network and all the computers in the network. Nmap -T4 -A -v 192.30.0.0/24 Name at least 5 different scans that may be performed from the ZenMap GUI and document under what circumstances you would choose to run those particular scans. What is the command line syntax for running an “Intense Scan” with ZenMap on a target subnet of 172.30.0.0/24? When I ping the “WindowsTarget01” VM server and the “UbuntuTarget01” VM server, ICMP echo-request / echo-replies of “Windows Target01” VM server varies like 8ms, 131ms, 33ms and <1ms. Minimum=0ms, Maximum=131ms, Average= 43ms If you ping the “WindowsTarget01” VM server and the “UbuntuTarget01” VM server, which fields in the ICMP echo-request / echo-replies vary? Read also A Survey "Fatigue Monitoring System" Packets: sent=4, Received=4, Lost=0 (0% loss)Īpproximate round trip times in milli-seconds: Run manually What was the DHCP allocated source IP host address for the Student VM, DHCP Server, and IP default gateway router?ĭHCP allocated the following IP addressesĭefault gateway router address is 192.168.1.1 Did the targeted IP hosts respond to the ICMP echo-request packet with an ICMP echo-reply packet when you initiated the “ping” command at your DOS prompt? If yes, how many ICMP echo-request packets were sent back to the IP source? Yes, four ICMP echo-request packets sent when I initiate a “ping” command from the DOS prompt
#NAME AT LEAST FIVE DIFFERENT SCANS THAT MAY BE PERFORMED WITH ZENMAP WINDOWS#
Lab Assessment Questions & Answers Name at least five applications and tools pre-loaded on the Windows 2003 Server Target VM (VM Name: “WindowsTarget01”) and identify whether that application starts as a service on the system or must be run manually? Using ZenMap GUI, students will then perform a “Ping Scan” or “Quick Scan” on the targeted IP subnetwork. In this lab, students will plan an attack on 172.30.0.0/24 where the VM server farm resides. Hackers traditionally perform an initial reconnaissance & probing scan to identify IP hosts, open ports, and services enabled on servers and workstations. The first step in performing an attack is to plan the attack by identifying your target and learning as much as possible about the target. Hackers traditionally follow a 5-step approach to seek out and destroy targeted hosts. Probing Using Zenmap Gui Computer Science Essay